1/9
April 2004s HIGH SPEED:t PD =3.6ns (TYP.)at V CC =5V s
LOW POWER DISSIPATION:I CC =1μA(MAX.)at T A =25°C s
HIGH NOISE IMMUNITY:
V NIH =V NIL =28%V CC (MIN.)
s POWER DOWN PROTECTION ON INPUTS s
SYMMETRICAL OUTPUT IMPEDANCE:|I OH |=I OL =8mA (MIN)at V CC =4.5V s
BALANCED PROPAGATION DELAYS:t PLH ?t PHL
s
OPERATING VOLTAGE RANGE:V CC (OPR)=2V to 5.5V
s
IMPROVED LATCH-UP IMMUNITY
DESCRIPTION
The 74V1G02is an advanced high-speed CMOS SINGLE 2-INPUT NOR GATE fabricated with sub-micron silicon gate and double-layer metal wiring C 2MOS technology.
The internal circuit is composed of 3stages including buffer output,which provide high noise immunity and stable output.
Power down protection is provided on all inputs and 0to 7V can be accepted on inputs with no regard to the supply voltage.This device can be used to interface 5V to 3V.
74V1G02
SINGLE 2-INPUT NOR
GATE
PIN CONNECTION AND IEC LOGIC SYMBOLS
ORDER CODES
PACKAGE T &R SOT23-5L 74V1G02STR SOT323-5L
74V1G02CTR
74V1G02
2/9
INPUT EQUIVALENT CIRCUIT
PIN DESCRIPTION
TRUTH TABLE
ABSOLUTE MAXIMUM RATINGS
Absolute Maximum Ratings are those values beyond which damage to the device may occur.Functional operation under these conditions is not implied.
RECOMMENDED OPERATING CONDITIONS
1)V IN from 30%to 70%of V CC
PIN N°SYMBOL NAME AND FUNCTION 11A Data Input 21B Data Input 41Y Data Output 3GND Ground (0V)
5
V CC
Positive Supply Voltage
A B Y L L H L H L H L L H
H
L
Symbol Parameter
Value Unit V CC Supply Voltage -0.5to +7.0V V I DC Input Voltage -0.5to +7.0V V O DC Output Voltage -0.5to V CC +0.5
V I IK DC Input Diode Current -20
mA I OK DC Output Diode Current ±20mA I O
DC Output Current
±25mA I CC or I GND DC V CC or Ground Current
±50mA T stg Storage Temperature
-65to +150
°C T L
Lead Temperature (10sec)
260
°C
Symbol Parameter
Value Unit V CC Supply Voltage 2to 5.5V V I Input Voltage 0to 5.5V V O Output Voltage 0to V CC V T op Operating Temperature
-55to 125°C dt/dv
Input Rise and Fall Time (note 1)(V CC =3.3±0.3V)
(V CC =5.0±0.5V)
0to 1000to 20
ns/V ns/V
74V1G02
3/9
DC SPECIFICATIONS
AC ELECTRICAL CHARACTERISTICS (Input t r =t f =3ns)
(*)Voltage range is 3.3V ±0.3V (**)Voltage range is 5.0V ±0.5V
CAPACITIVE CHARACTERISTICS
1)C PD is defined as the value of the IC’s internal equivalent capacitance which is calculated from the operating current consumption without load.(Refer to Test Circuit).Average operating current can be obtained by the following equation.I CC(opr)=C PD x V CC x f IN +I CC
Symbol
Parameter
Test Condition
Value Unit
V CC (V)T A =25°C -40to 85°C -55to 125°C Min.Typ.
Max.
Min.Max.
Min.Max.
V IH
High Level Input Voltage 2.0 1.5 1.5 1.5V
3.0to 5.50.7V CC
0.7V CC
0.7V CC
V IL
Low Level Input Voltage
2.00.50.50.5V
3.0to 5.50.3V CC
0.3V CC
0.3V CC
V OH
High Level Output Voltage
2.0I O =-50μA 1.9 2.0 1.9 1.9V
3.0I O =-50μA 2.9 3.0 2.9 2.9
4.5I O =-50μA 4.4 4.5
4.4 4.43.0I O =-4mA 2.58 2.48 2.44.5
I O =-8mA 3.94
3.8
3.7
V OL
Low Level Output Voltage
2.0I O =50μA 0.00.10.10.1V
3.0I O =50μA 0.00.10.10.1
4.5I O =50μA 0.0
0.10.10.13.0I O =4mA 0.360.440.554.5
I O =8mA 0.360.440.55I I Input Leakage Current
0to 5.5V I =5.5V or GND ±0.1±1±1μA I CC
Quiescent Supply Current
5.5
V I =V CC or GND
1
10
20
μA Symbol
Parameter
Test Condition
Value
Unit
V CC (V)C L (pF)T A =25°C -40to 85°C -55to 125°C Min.
Typ.Max.Min.Max.Min.Max.t PLH t PHL Propagation Delay
Time
3.3(*)15
4.78.0 1.09.5 1.010.5ns 3.3(*)50
5.29.0 1.010.5 1.011.55.0(**)15 3.6 5.5 1.0
6.5 1.0
7.55.0(**)
50
4.5
7.0
1.0
8.5
1.0
9.5
Symbol
Parameter
Test Condition
Value Unit
T A =25°C -40to 85°C -55to 125°C Min.
Typ.Max.Min.
Max.Min.
Max.C IN Input Capacitance 410
10
10
pF C PD
Power Dissipation Capacitance (note 1)
10
pF
74V1G02
4/9
TEST CIRCUIT
L R T =Z OUT of pulse generator (typically 50?)
WAVEFORM:PROPAGATION DELAY (f=1MHz;50%duty
cycle)
74V1G02
7/9
74V1G02 Information furnished is believed to be accurate and reliable. However, STMicroelectronics assumes no responsibility for the consequences of use of such information nor for any infringement of patents or other rights of third parties which may result from its use. No license is granted by implication or otherwise under any patent or patent rights of STMicroelectronics. Specifications mentioned in this publication are subject to change without notice. This publication supersedes and replaces all information previously supplied. STMicroelectronics products are not authorized for use as critical components in life support devices or systems without express written approval of STMicroelectronics.
The ST logo is a registered trademark of STMicroelectronics
All other names are the property of their respective owners
? 2004 STMicroelectronics - All Rights Reserved
STMicroelectronics GROUP OF COMPANIES
Australia - Belgium - Brazil - Canada - China - Czech Republic - Finland - France - Germany - Hong Kong - India - Israel - Italy - Japan - Malaysia - Malta - Morocco - Singapore - Spain - Sweden - Switzerland - United Kingdom - United States.
https://www.wendangku.net/doc/089465392.html,
9/9