R50RED-F-0160
? RoHS Compliant
? Low Profile Dome Lens
? Automatic Insertion Compatible — Tubular Packaging ? Automatic Placement Compatible ? High Intensity Output ?
High Power Efficiency
Bivar R50RED-F-0160 comes with low profile package design incorporating higher forward current to max-imize intensity while minimizing the number of LEDs required to achieve uniform and enhanced light distri-bution. Low power consumption with quick response time means savings in electricity.
Bivar R50RED-F-0160 can be coupled with reflectors or lenses for optimal light distribution needs. Typical applications are automotive exterior lighting, decorative interior or exterior lighting, specialty stage lighting, and electronic signage.
Part Number
Material
Emitted Color
Intensity Typ. mcd
Lens Color Viewing Angle
R50RED-F-0160 AlGaInP/GaAs
Red
600
Water Clear
160°
Outline Drawings Notes:
1. All dimensions are in inches [millimeters].
2. Standard tolerance: ±0.010" unless otherwise noted.
3. Tolerance of overall epoxy outline: ±0.020" unless otherwise noted. CAUTION: LOOKING DIRECTLY AT LED WITHOUT SHIELDED EYES ATTENTION
OBSERVE PRECAUTIONS
FOR HANDLING ELECTROSTATIC
Moisture Sensitivity Levels 1
Absolute Maximum Ratings
T A = 25°C unless otherwise noted Power Dissipation 140 mW Forward Current ( DC ) 80 mA Peak Forward Current 1
160 mA Electrostatic Discharge ( Class1 ) 1000 V
Reverse Voltage
5 V
Operating Temperature Range -25 ~ +80°C Storage Temperature Range
-30 ~ +80°C
Lead Soldering Temperature ( 3 mm from the base of the epoxy bulb ) 2 260°C
1. 10% Duty Cycle, Pulse Width ≤ 0.1 msec.
2. Solder time less than 5 seconds at temperature extreme.
Notes: Electrical Characteristics
T A = 25°C & I F = 50 mA unless otherwise noted
Relative Luminous Intensity vs. Radiation Angle
Directivity Radiation
T A = 25°C unless otherwise noted
1. Tolerance of Forward Voltage : ±0.05V.
2. Tolerance of Dominant Wavelength : ±0.1nm.
3. Tolerance of Luminous Intensity : ±15%.
Notes: Emitting
Color
Forward Voltage (V)1 Recommend Forward Current (mA)
Reverse Current (μA) V R =5V Dominant
Wavelength (nm)2 Viewing
Angle
2 ? ? (deg)
MIN TYP MAX
TYP MAX MIN MAX MIN TYP TYP Red
2.0
2.4
2.8
50
10
620
635
400
600
160
Luminous Intensity (mcd)3
Typical Electrical / Optical Characteristics Curves T A = 25°C unless otherwise noted
Fig.5 Relative Luminous Intensity vs. Ambient Temperature
Recommended Soldering Conditions
Bivar Orca R series Super Flux LEDs are packaged in tubes, each of which contains 60 LEDs; and each tube contains a rubber stopper at each end.
Packaging and Labeling Plan
Preheat Temperature: 100oC Max. Peak Temperature: 260oC Max.
Preheat Time: 20 ~ 50 Seconds
Solder Time Above 217oC: 5 Seconds Max.
Note: Turn off top heater at preheat to prevent the lamp body directly exposed to the heat source.
Recommended Lead Free Wave Soldering Profile