英文文献阅读笔记精编版

英文文献阅读笔记精编

版

MQS system office room 【MQS16H-TTMS2A-MQSS8Q8-MQSH16898】

英文文献阅读笔记

Title：Distributed Virtual Inertia Based Control of Multiple Photovoltaic Systems in Autonomous Microgrid

Author：Won-Sang Im, Member, IEEE, Cheng Wang, Student Member, IEEE, Wenxin Liu, Senior Member, IEEE, Liming Liu, Senior Member, IEEE, and Jang-Mok Kim, Member, IEEE

Source：IEEE/CAA JOURNAL OF AUTOMATICA SINICA, VOL. 4, NO. 3, JULY 2017

Research question：

Since an autonomous renewable microgrid usually has much smaller inertia, the control system must be very fast and accurate to fight against the small inertia and uncertainties. To reduce the demanding requirements on control, this paper proposes to increase the inertia of photovoltaic (PV) system through inertia emulation.

在摘要中作者简要叙述了本文研究内容即：寻找一种方法来增加PV 系统的惯性以降低系统的控制要求。同时，在Introduction部分，作者进一步对研究问题进行了详细的描述。

Methods：

The inertia emulation is realized by controlling the charging/discharging of the direct current (DC)-link capacitor over a certain range and adjusting the PV generation when it

is feasible and/or necessary. By well designing the inertia, the DC-link capacitor parameters and the control range, the negative impact of inertia emulation on energy efficiency can be reduced.The proposed algorithm can be integrated with distributed generation setting algorithms to improve dynamic performance and lower implementation requirements. Simulation studies demonstrate the effectiveness of the proposed solution.

为了克服系统惯性较低的问题，作者提出了一种新的控制方法，在对此方法进行推导与演算之后又用软件仿真的方式验证了此方法的周期性。

Findings/results：

In spite of the disconnection form the grid at 20 s or 5% load increase change at 40 s, the system can be controllable to satisfy the supply-demand , it is because of the increased system inertia. In this test, inertia coefficient HPV for two PVs are both . If the two inertia coefficients are lower than 4, the system becomes unstable after 20 s. As shown in Figs.

12 (c) and 12 (d), the two PV systems are generating the active powers based on the virtual inertia algorithm so that it can prevent frequency collapse. Therefore, the proposed virtual inertia control can help stabilizing system when the upper-level control reference cannot be delivered frequently enough.

Fig. 12. Active power of 5 RGs with the proposed algorithm 作者在对比了使用这种新的控制算法前后的仿真波形图之后，得出来此种控制方法在一定的应用范围内，具有更优的控制性能的结论。Discussion/conclusion：

Conclusion可以分为以下五个小部分：

(1)Restatements of the research question: This paper

presents a virtual inertia control strategy for PV systems in autonomous microgrid. The basic idea is to adjust generation based on a simplified SG model. The increasing or decreasing PV system generation is realized by adjusting the DC-link voltage and PV array output.

(2)Discussion of the result: By integrating the

proposed solution with a previously developed distributed gradient-based coordination algorithm, transient performance can be improved and the demanding requirement on updating frequency can be relaxed.

(3)Significance of the research:The solution is

suitable for autonomous microgrids when they have surplus renewable generation and when consideration on transient performance outweighs energy efficiency. The basic idea can be extended to other types of RGs with DC-link capacitors.

(4)Limits of the research: The solution tries to make

microgrid work like a large power grid with large inertia.

Thus, it cannot unlock the potentials of power electronics based microgrid in terms of flexibility and fast response.

(5)Further research work:Future work should be

focused on designing advanced fast and accurate microgrid controllers.

Tone：weak

Indicative sentence pattern：

A model isdeveloped for a…

The objective of…is to…

According to…

From …one can see that…

The experimental results reveal that…

Relevance to my study：

The direction of my research is motor and electrical appliances. The circuit topology used in this document is one of the most applied circuit structures in our electrical specialty. Reading this article is very helpful for us to master the characteristics of this circuit topology. The control method proposed in this paper has also solved the problem of the difficult control of the microgrid system. At the same time, we can extend it and apply this control method to other power generation systems. This provides a new way of thinking for our future research and study.