AK NetApp at a glance6

Next steps:

1. Upgrade DOT, shelf firmware and disk firmware to 7.3.6 for all IAKFiler1/2

2. Determine what snap mirrors and TSM backups are needed and if additional capacity is needed to supp

3. Develop proposals for addressing all remaining issues in AK NetApp environment

a. Support existing environment by replacing old controllers, out of support hardware

b. Determine where additional capacity is needed in the environment

4. Replace AKFiler6/7 and AKFiler8 with new models and retire by end of 2012. Reclaim any shelves that

5. Replace IAKFiler1/2 with new models and retire by June 2013

6. Once AKFiler3, NTAP-1, AKFiler6/7, AKFiler8 are retired, the remaining arrays can be upgraded to

7. Start working on lifecycle and capacity plans for NetApp in AK for 2013

KFiler1/2

onal capacity is needed to support them through 2012

nvironment

of support hardware

2012. Reclaim any shelves that can be reused elsewhere in the environment (can use capacity to retire out of sup ning arrays can be upgraded to DOT 8.1 IAKFiler1/2 don't impact this because they don't replicate except to

e capacity to retire out o

f support drives) they don't replicate except to each other.