HCC/HCF4093B
QUAD 2-INPUT NAND SCHMIDT TRIGGERS
.SCHMITT-TRIGGER ACTION ON EACH INPUT WITH NO EXTERNAL COMPONENTS
.HYSTERESI S VOLTAGE TYPICALLY 0.9V AT V DD =5V AND 2.3V AT V DD =10V
.NOISE IMMUNITY GREATER THAN 50%OF V DD (typ.)
.NO LIMIT ON INPUT RISE AND FALL TIMES .STANDARDIZED SYMMETRICAL OUTPUT CHARACTERISTICS
.QUIESCENT CURRENT SPECIFIED TO 20V FOR HCC DEVICE
.5V,10V,AND 15V PARAMETRIC RATINGS .INPUT CURRENT OF 100nA AT 18V AND 25°C FOR HCC DEVICE
.100%TESTED FOR QUIESCENT CURRENT .
MEETS ALL REQUIREMENTS OF JEDECTEN-TATIVE STANDARD N °.13A,”STANDARD SPECIFICATIONS FOR DESCRIPTION OF ”B”SERIES CMOS DEVICES”
June 1989
EY
(Plastic Package)F
(Ceramic Frit Seal Package)
C1
(Plastic Chip Carrier)
ORDER CODES :
HCC4093BF HCF4093BM1HCF4093BEY HCF4093BC1
PIN CONNECTIONS
M1
(Micro Package)
DESCRIPTION
The HCC4093B (extended temperature range)and HCF4093B (intermediate temperature range)are available in 14-lead dual in-line plastic or ceramic package and plastic micropackage.The HCC/HCF4093B consists of four Schmitt-trigger cir-cuits.Each circuit functions as a two-input NAND gate with Schmitt-trigger action on both inputs.The gate switches at different points for positive and ne-gative-going signals.
The difference between the positive voltage (V P )and the negative voltage (V N )is defined as hys-teresis voltage (V H )(see fig.1).
1/13
FUNCTIONAL DIAGRAM ABSOLUTE MAXIMUM RATINGS
Symbol Parameter
Value Unit V DD *Supply Voltage :HCC Types
HCF Types –0.5to +20–0.5to +18V V V I Input Voltage
–0.5to V DD +0.5
V I I DC Input Current (any one input)
±10mA P t o t
Total Power Dissipation (per package)Dissipation per Output Transistor
for T o p =Full Package-temperature Range 200100mW mW T o p Operating Temperature :HCC Types
HCF Types –55to +125–40to +85°C °C T s t g
Storage Temperature
–65to +150
°C
RECOMMENDED OPERATING CONDITIONS
Symbol Parameter
Value Unit V DD Supply Voltage :HCC Types
HCF Types 3to 183to 15V V V I Input Voltage
0to V DD V T o p
Operating Temperature :HCC Types
HCF Types
–55to +125–40to +85
°C °C
Stresses above those listed under ”Absolute Maximum Ratings ”may cause permanent damage to the device.This is a stress rating only and functional operation of the device at these or any other conditions above those indicated in the operational sec-tions of this specification is not implied.Exposure to absolute maximum rating conditions for external periods may affect device reliability.
*All voltage values are referred to V SS pin voltage.
1of 4Schmitt triggers
HCC/HCF4093B
2/13
STATIC ELECTRICAL CHARACTERISTICS (over recommended operating conditions)
Test Conditions
Value V I
V O |I O |V D D T L o w *
25°C T Hi g h *Symbol Parameter (V)(V)(μA)(V)Min.Max.
Min.Typ.Max.Min.Max.
Unit
I L
Quiescent Current
HCC
Types 0/5510.02130μA
0/101020.022600/151540.0241200/2020200.0420600HCF Types
0/5540.024300/101080.028600/151516
0.0216120V P
Positive Trigger Threshold Voltage
a 5 2.2 3.6 2.2 2.9 3.6 2.2 3.6V
a 10 4.67.1 4.6 5.97.1 4.67.1a 15 6.810.8 6.88.810.8 6.810.8
b 5 2.64 2.6 3.34 2.64b 10 5.68.2 5.678.2 5.68.2b 15 6.312.7 6.39.412.7 6.312.7V N
Negative Trigger Threshold Voltage
a 50.9 2.80.9 1.9 2.80.9 2.8V
a 10 2.5 5.2 2.5 3.9 5.2 2.5 5.2a 1547.44 5.87.447.4
b 5 1.4 3.2 1.4 2.3 3.2 1.4 3.2b 10 3.4 6.6 3.4 5.1 6.6 3.4 6.6b 15 4.89.6 4.87.39.6 4.89.6V H Hysteresis Voltage
a 50.3 1.60.30.9 1.60.3 1.6V
a 10 1.2 3.4 1.2 2.3 3.4 1.2 3.4a 15 1.65 1.6 3.55 1.65
b 50.3 1.60.30.9 1.60.3 1.6b 10 1.2 3.4 1.2 2.3 3.4 1.2 3.4b 15 1.65 1.6 3.55 1.65V OH
Output High Voltage 0/5<15 4.95 4.95 4.95V
0/10<1109.959.959.950/15<11514.95
14.9514.95
V OL
Output Low Voltage 5/0<150.050.050.05V
10/0<1100.050.050.0515/0<1150.050.050.05
I OH
Output Drive Current
HCC Types
0/5 2.55–2–1.6–3.2–1.15mA
0/5 4.65–0.64–0.51–1–0.360/109.510–1.6–1.3–2.6–0.90/1513.515–4.2–3.4–6.8–2.4HCF Types
0/5 2.55–1.53–1.36–3.2–1.10/5 4.65–0.52–0.44–1–0.360/109.510–1.3–1.1–2.6–0.90/1513.515
–3.6
–3.0–6.8–2.4
a :input on terminals 1,5,8,12or 2,6,9,13;other inputs to V DD .
b :input on terminals 1and 2,5and 6,8and 9,or 12and 13;other inputs to V DD .*T Low =–55°C for HCC device :-40°C for HCF device.*
T High =+125°C for HCC device :+85°C for HCF device.
HCC/HCF4093B
3/13
STATIC ELECTRICAL CHARACTERISTICS (continued)
Test Conditions
Value
V I V O |I O |V D D T L o w *25°C T Hi g h *Symbol Parameter (V)(V)(μA)(V)Min.Max.Min.Typ.Max.Min.Max.
Unit
I OL
Output Sink Current
0/50.450.640.5110.36mA
0/100.510 1.6 1.3 2.60.90/15 1.515 4.2 3.4 6.8 2.40/50.450.520.4410.360/100.510 1.3 1.1 2.60.90/15
1.5
15 3.6
3.0
6.8 2.4
I IH ,I IL
Input Leakage Current
HCC
Types 0/18
Any Input
μA
18
±0.1
±10-5±0.1±1
HCF
Types
0/15
15
±0.3
±10-5±0.3±1
C I Input Capacitance
Any Input
5
7.5
pF DYNAMIC ELECTRICAL CHARACTERISTICS (T amb =25°C,C L =50pF,R L =200k ?,typical temperature coefficient for all V DD =0.3%/°C values ,all input rise and fall time =20ns)
Value Symbol
Parameter
Test Conditions
V D D (V)Min.
Typ.Max.Unit
t P L H ,t P HL Propagation Delay Time
5190380ns 109018015
65130t TL H ,t T HL
Transition Time
5100200ns 105010015
40
80
Figure1:Hysteresis Definition,Characteristics and Test Setup.(a)Definition of V P ,V N and V H
(b)Transfer characteristics of 1of 4gates
HCC/HCF4093B
4/13
HCC/HCF4093B (c)Test setup F igure2:Input and Output Characteristics.
F igure3:Typical Current and Voltage Transfer Characteristics.
Figure4:Typical Voltage Transfer Characteristics as a Function of Temperature,and Test Circuit.
5/13
Figure5:Typical Output Low(sink)Current Char-acteristics.Figure6:Minimum Output Low(sink)Current Char-acteristics.
Figure7:Typical Output High(source)Current Characteristic.Figure8:Minimum Output High Current Charac-teristics.
Figure9:Typical Propagation Delay Time vs.Sup-ply Voltage.Figure10:Typical Transition Time vs.Load Capa-citance.
HCC/HCF4093B 6/13
Figure11:Typical Trigger Threshold Voltage vs.V DD Figure12:Typical per cent Hysteresis vs.Supply Voltage.
Figure13:Typical Dissipation Characteristics.Figure14:Power Dissipation vs.Rise and Fall
Times.
HCC/HCF4093B
7/13
APPLICATIONS Figure 15:Wave Shaper.
Figure 16:Monostable Multivibrator.
Figure17:Astable Multivibrator.
Figure 19:Input Leakage Current.
TEST CIRCUITS
Figure18:Quiescent Device Current.
HCC/HCF4093B
8/13
HCC/HCF4093B Plastic DIP14MECHANICAL DATA
mm inch
DIM.
MIN.TYP.MAX.MIN.TYP.MAX.
a10.510.020
B 1.39 1.650.0550.065
b0.50.020
b10.250.010
D200.787
E8.50.335
e 2.540.100
e315.240.600
F7.10.280
I 5.10.201
L 3.30.130
Z 1.27 2.540.0500.100
P001A
9/13
HCC/HCF4093B
Ceramic DIP14/1MECHANICAL DATA
mm inch DIM.
MIN.TYP.MAX.MIN.TYP.MAX.
A200.787 B7.00.276
D 3.30.130
E0.380.015
e315.240.600
F 2.29 2.790.0900.110
G0.40.550.0160.022
H 1.17 1.520.0460.060
L0.220.310.0090.012 M 1.52 2.540.0600.100 N10.30.406 P7.88.050.3070.317 Q 5.080.200
P053C 10/13
HCC/HCF4093B
SO14MECHANICAL DATA
mm inch
DIM.
MIN.TYP.MAX.MIN.TYP.MAX.
A 1.750.068
a10.10.20.0030.007
a2 1.650.064
b0.350.460.0130.018
b10.190.250.0070.010
C0.50.019
c145°(typ.)
D8.558.750.3360.344
E 5.8 6.20.2280.244
e 1.270.050
e37.620.300
F 3.8 4.00.1490.157
G 4.6 5.30.1810.208
L0.5 1.270.0190.050
M0.680.026
S8°(max.)
P013G
11/13
HCC/HCF4093B
PLCC20MECHANICAL DATA
mm inch DIM.
MIN.TYP.MAX.MIN.TYP.MAX.
A9.7810.030.3850.395 B8.899.040.3500.356
D 4.2 4.570.1650.180
d1 2.540.100
d20.560.022
E7.378.380.2900.330
e 1.270.050
e3 5.080.200
F0.380.015
G0.1010.004 M 1.270.050
M1 1.140.045
P027A 12/13
HCC/HCF4093B Information furnished is believed to be accurate and reliable.However,SGS-THOMSON Microelectronics assumes no responsability for the consequences of use of such information nor for any infringement of patents or other rights of third parties which may results from its use.No license is granted by implication or otherwise under any patent or patent rights of SGS-THOMSON Microelectronics.Specificationsmentioned in this publication are subject to change without notice.This publication supersedes and replaces all information previously supplied.
SGS-THOMSON Microelectronics products are not authorized for use ascritical components in life support devices or systems without express written approval of SGS-THOMSON Microelectonics.
?1994SGS-THOMSON Microelectronics-All Rights Reserved
SGS-THOMSON Microelectronics GROUP OF COMPANIES
Australia-Brazil-France-Germany-Hong Kong-Italy-Japan-Korea-Malaysia-Malta-Morocco-The Netherlands-
Singapore-Spain-Sweden-Switzerland-Taiwan-Thailand-United Kingdom-U.S.A
13/13