EGN-J-V110B中文资料
Dimensions are shown: mm (inch)
Specifications and dimensions subject to change
https://www.wendangku.net/doc/ca8221920.html,
C–19
Navigation
-Joystick footprint and actuator height (scalable per the design rules)-Joystick top cap (plastic or silicone; color & fashion)
-Joystick plastic retainer (reference retainer integratable to device chassis per the design rules)
-Dedicated microcontroller (contains firmware for quick I/O interface, or firmware compiled into device controller)
Series Values
EGN-Jx3x-xx
EGN-Jx2x-xx
PCB FOOTPRINT REQUIREMENT (mm):
16.3 topside,19.3 topside 17.3-20.317.3 bottom 20.3 bottom PCB TO ACTUATOR TIP HEIGHT (mm): 5.8-7.5 5.8
7.5
MIN ACTUATION ANGLE (deg):
less than 2less than 2 less than 2MAX DEFLECTION FROM VERTICAL (deg):
2525
25
LATERAL FORCE @ MIN ACTUATION (g force): 23-2423 or less 24 or less LATERAL FORCE @ MAX ACTUATION (g force):74-12074120MIN VERTICAL FORCE TO ACTIVATE (g force):9-20920DOME SWITCH ACTUATION FORCE (g force):
210-380210380SINGLE LARGE LATERAL FORCE SURVIVABLE (g force):
2000
2000
2000
User Interface
NUMBER OF AXSIS PROVIDED: 1, 2, 4 & continous DIRECTIONS/VECTORS:
>360
NUMBER OF RATE STEPS FROM FULL: Up to 1024SOUTH to FULL NORTH DEFLECTION 64 standard POSITION SAMPLING RATE: 25-40hz
40hz standard SIGNAL LATENCY:
< 4ms
Features/Benefits
?Omni-directional analog control ?Variable speed (rate and control)?Small form factor
?Low power (instant wake-up)?Integrated switch (center click)
?True deflection device (pointing device)?Simple electrical interface ?Environmental protection ?Long life
Typical Applications ?Cell phones
?Gaming devices ?MP3 players ?PDA’s
?GPS devices ?Remote controls ?Laptops
?Convergent devices ?Others
ERGO-NAV EGN-J Series
Analog Joystick Navigation Device
N
E W !
LINEARITY OF DEVICE OUTPUT:
R^2>0.97REPEATABILITY OF SINGLE DEVICE OUTPUT:±2%
SETTING TIME OF SIGNAL VOLTAGE IN DEVICE:Negligible RESISTANCE FOR NS OR EW AXIS:
400-10,000?JOYSTICK NOT ACTUATED RESISTANCE:
10M ?
DOME SWITCH OPEN/CLOSED RESISTANCE: 500k ?/250?POWERING VOLTAGES:
1.8-5
# OF A/D INPUTS REQUIRED: One 8 bit ADC # OF GPIO INTERFACE NEEDED: 5
ROM REQUIREMENTS:
10kb max CONTINUOUS USE CURRENT PEAK*TYPICAL/WORST CASE:
3.1/8.3 mA CONTINUOUS USE CURRENT AVERAGE*TYPICAL/WORST CASE:
62/165μA SLEEP POWER CONSUMPTION:
0μW
* Typical transducers are 800-1600 ohms, worse case current is for 400 ohm transducer
OPERATING LIFE (DEFLECTIONS):
>3M DOME SWITCH OPERATING LIFE, (CYCLES):500,000VIBRATION:
No Effects PULLOUT FORCE:2kgf/4.5lbf DROP TEST: Pass EMI/EMC: Pass ESD RATING:
Pass
ERGO-NAV EGN-J Series
Analog Joystick Navigation Device
RELIABILITY
ENVIRONMENTAL
ELECTRICAL/SOFTWARE
Series Values
Series Values
OPERATING TEMP (deg C): -10 TO 45STORAGE TEMP (deg C):-30 TO 70SHIPPING ALTITUDE (feet):40,000ft (0.2 atm)RELATIVE HUMIDITY:0-85%DUST PROTECTION: IP5X CONTAMINATION RESISTANCE: BABY
OIL, HAND CREAM: No effect ROBUST CONTAMINANT RESISTANCE; WATER,
SUGAR WATER, SALT WATER, COFFEE: IPX4
Series Values
N a v i g a t i o
n
C–20
https://www.wendangku.net/doc/ca8221920.html,
Dimensions are shown: mm (inch)
Specifications and dimensions subject to change
Dimensions are shown: mm (inch)
Specifications and dimensions subject to change
https://www.wendangku.net/doc/ca8221920.html,
C–21
Navigation
ERGO-NAV EGN-J Series
Analog Joystick Navigation Device
PCB with switch
** Reference only