FREQUENCY
QEUM5 / QEUM5-GW
UM5 Crystal – Through Hole & Gull Wing SMD packaged Specification (Rev-C)
Electrical Characteristics ......................................................P01
ESR vs. frequency range and Mode of vibration ..................P01
Mechanical Characteristics...................................................P01
Ordering Information.............................................................P02
QEUM5-GW Tape Drawing ..................................................P02
元器件交易网https://www.wendangku.net/doc/e211741140.html,
QEUM5 / QEUM5-GW
UM5 Crystal – Through Hole & Gull Wing SMD packaged
Specification (rev-C) October 03rd , 2006
Electrical Characteristics
Electrical Parameters
Unit Minimum Typical Maximum Test conditions Frequency range MHz 10
200
Frequency Tolerance (at 25°C) ± ppm 10 30 50 Refer to Ordering Information Temperature Stability
± ppm 10 30 50
Refer to Ordering Information Operating Temperature Range °C -20/+70
-40/+85 Refer to Ordering Information Storage temperature range °C -40 +85
Shunt capacitance C 0 pF
7.0
Load capacitance pF 10pF ~ 32pF or series Refer to Ordering Information Drive level μW 100 500
Aging (First Year) ± ppm 3 Ref at 25°C Insulator resistance M ?
500
At 100V DC
Customized specification upon request
ESR vs. frequency range and Mode of vibration
Frequency range (MHz) Mode of vibration Max ESR (?)Frequency range (MHz)Mode of vibration Max ESR (?)
10.000 to 19.999
Fund. 60 80.000 to 105.000 3rd 80 20.000 to 40.000 Fund. 40 60.000 to 129.999 5th 200 30.000 to 79.999
3rd
100
130.000 to 200.000
7th
180
Mechanical Characteristics
? 0.35 ± 0.05mm
QEUM5 / QEUM5-GW
UM5 Crystal – Through Hole & Gull Wing SMD packaged
Specification (rev-C) October 03rd , 2006
Ordering Information
QEUM5-GW Tape Drawing
Mechanical conditions
Vibration 10g, 10Hz to 2KHz
according to standard CEI 68-2-63
Shocks 100g, 6ms according to
standard CEI 68-2-27
Marking for QEUM5 Marking for QEUM5-GW Line 1
VRDxxx (Temex code) VRSxxx (Temex code) Line 2 Frequency in MHz (6 digits)
Frequency in MHz (6 digits)
Line 3 YYWW – production code YYWW – production code
Item Symbol
Dimensions
Pitch of components P 12 ± 0.1 Pitch of sprocket hole P O 4 ± 0.1 Length from hole to component center P1 2 ± 0.1 Width of carrier tape W 24 ± 0.3 Width of adhesive tape W 1 11.5 ± 0.1 Gap of hold down tape W 2 1.75 ± 0.1 Diameter of feed hole D O ? 1.5 min Diameter of sprocket hole D 1
? 1.5 ± 0.1
Note 1 : Metal Clips are opposed to the the sprocket holes.
Note 2 : Multiple is 1Kpcs per reel.
Note : QEUM5 & QEUM5-GW are fully RoHS compliant.