Dimensions are shown in mm Dimensions subject to change
https://www.wendangku.net/doc/e813196614.html,
Contacts Copper alloy
Plating
Contact area : Gold alloy inlay Terminals: Tin lead (2μmin)
Moldings High temp. thermoplastic UL 94V-0 rated Spring
Stainless steel Card detection switch actuator Stainless steel
Number of Contacts 8
Mechanical life
500,000 cycles min Card insertion force 10 N max
Card extraction force 1 N min / 10 N max Contact force
0.25 N min / 0.5 N max
Card detection switch 0.8 N max for actuation (end travel switch actuation force actuates when card is 1,0 mm from
card stop)1.8 N max for complete depression Vibration Frequency 10 to 500 Hz. Acceleration 50m/s 2Duration 6 hours - amplitude 0,35 mm Max electrical discontinuity 1μs
Shock
Peak value 500 m/s 2– Duration 11 ms 3 shocks in each direction of each axis
Insulation resistance
1,000 M ?
min
Resistance 100 m
?max Current rating
10 μA min / 1 A max Dielectric strength 750 Vrms min Card detection switch Normally open Contact resistance 100 m ?max Dielectric strength 250 Vrms min
Maximum power 0.2 VA
Operating temperature -40°C to +85°C
Soldering temperature Temperature/time pro?le acc. to CECC00802para. 6.1, Fig. 3 with peak temperature 250°C Damp heat IEC 512 test number 11c (10 days)Salt mist
IEC 512 test number 11f (96 hours)30 per tray, 10 trays per box.
CCM02 MK II
The CCM02 MK II connectors with landing contacts are dedicated for applications where the reader usage is high and the life span of the card is a key consideration. A connector with contacts which land on the card, rather than slide over it, should be speci?ed so as to minimize card wear. The CCM02has been redesigned to give an even higher performance in a compact,affordable package.Features
? 500,000 card insertion cycles.? The contacts do not touch the card until it is almost fully inserted – A minimal wiping action removes any non-conductive material.
? The connector has been designed to give a positive indication once the card has been fully inserted.
? The reduced size of the contact base saves PCB space, making the
connector more stable during surface mounting, and creates an air gap between the contacts and card entry slot, which reduces the risk of an electrostatic transfer to the PCB.? For added reliability, the integrated card end-travel switch, which is normally open, is sealed against dust and grit.? By using an inlay ?nish in the contact area, the life of the precious metal is extended by more than 10 times that of standard gold plating.
? The contact area is spooned to reduce the risk of accidental (or deliberate)damage and to optimize the electrical connection with the card.
? Snap-locks underneath the molding position and hold the connector on the PCB, and give additional support to the contact terminals.
? The plastic moldings are made from a high temperature thermoplastic suited for infrared and convection soldering processes.
EMV TM is a trademark owned by EMVCoLLC.
EMV TM compatible
CCM02 MK II
Dimensions are shown in mm
Dimensions subject to change
https://www.wendangku.net/doc/e813196614.html,